1School of Water Sciences Engineering, Shahid Chamran University
2Department of Hydraulic Structures, School of Water Sciences Engineering, Shahid Chamran University
This paper presents an experimental study the influence of wave parameter on the damage of reshaping seawall, model tests have been performed in several water level conditions. The experiments of physical modeling of this research have been done in the flume of the Soil Conservation and Watershed Management Research Institute (SCWMRI). The waves applied to the structure model are irregular and the energy spectrum of the applied waves is JONSWAP. The material of arm our layer have been regarded with the scale of 1:25 model and grading class of D85/D15=1.82. A number of 3000 waves were applied on the structure over the research in general and some 60 experiments have been totally accomplished. The results of tests after drawing graphs, has been analyzed. That it can be harvested with %82 increasing in wave steepness, damage parameter %85 decreased and also with %57 increasing in wave height, the damage parameter %87 increases and with %57 increasing in wave length, the damage will %83 increase.
Aghtouman, P.; Chegini, V.; Shirian, N.; Hejazi, M., (2005). Design of reshaping breakwater’s armor layer thickness. 2nd International “Coastal
Symposium”(Hofn, Iceland, June 2005).
Aghtouman, P.; Aliyari, F.; Aghtouman, Z., (2011). Effect of berm width on reshaped profile of berm breakwaters. 5th “International Short Conference on Applied Costal Research”(Aachen, Germany, June 2011).
Baird, W. F.; Hall, K. R., (1984). The design of breakwaters using quarried stone. 19th “International Conference on Coastal Engineering” (Houston, USA).
CIRIA, CUR., (1991). Manual on the use of rock in coastal and shoreline engineering. CIRIA, London and CUR, Rotterdam, Netherland.
Hughes, S. A., (1993). Physical models and laboratory techniques in coastal engineering advanced Series on Ocean engineering, Vol. 7, World Scientific Publishing, Singapore.
Kao, J. S; Hall, K. R., (1990). Trends in stability of dynamically stable breakwaters. ASCE. Proc. 22nd ICCE, Delft, Netherland.
Rao, S.; Pramod, Ch. ; Rao, B., (2003). Stability of berm breakwater with reduced armor stone weight, Technical Note, Ocean Engineering 31,1577-1589.
Sayao, O.J.,(1998). On the profile reshaping of berm breakwaters, Coastal structures 99, 224-265.
Torum, A.; Kuhnen, F.; Menze, A., (2002). On berm breakwaters, Stability, Scour, Overtopping, Coastal Engineering 49, 209-238.
Vander Meer, J. W., (1988). Rock slopes and gravel beaches under wave attack. Doctoral Thesis, Delft University of Technology, Also: Delft Hydraulics Communication No. 396.
Van derMeer, J. W., (1994). Conceptual design of rubble mound breakwaters. Delft Hydraulics Publication No. 483.
Van der Meer, J. W.; Veldman, J. J., (1992). Stability of the seaward slope of berm breakwaters. Elsevier, Journal of Coastal Engineering, Amsterdam, September, 205-234.